Electronics > Repair

Fluke 289 not quite sorted.

<< < (11/49) > >>

frenky:
Some research...

Fluke 287/289 are using RedBoot/eCos:

--- Quote ---eCos and RedBoot based products showcase
Industrial and Automotive
Fluke 289 and 287 True-RMS Multimeters. Fluke's "The Most Advanced Multimeters, Ever", data logging & graphing multimeters.
--- End quote ---
https://lists.ecoscentric.com/ecos/examples.shtml

So I have been reading alot about RedBoot and found this:

--- Quote ---Accessing RedBoot
After all connections have been made, start the serial terminal application and apply power to the board. Press Ctrl+C several times on the serial terminal until you see the RedBoot> prompt. If the kernel begins to boot, reset the board and try again (the standard timeout before booting the kernel is one second). On most versions of RedBoot, you will see either a '+' or a message from RedBoot before it boots the kernel, but some configurations have this disabled.
--- End quote ---
http://wiki.emacinc.com/wiki/Loading_Images_with_RedBoot

So the reason that I could not write to console is that I was trying to do it after the kernel has already booted.
So I'll try sending in Ctrl+C every half a second and then power up the Fluke 287. Hopefully I'll be able to access console this way...

purpose:
Incoming.

purpose:
9V TO PADS, IN AC V MODE, ALL READINGS RELATIVE TO NEG PAD.

TP
1   0.005
2   3.11
3   4.99
4   3.11
5   3.09
6   3.09
7   0.00
8   9.00
9   2.30
10  0.00
11  0.158
12  0.00
13  3.06
14  0.00
15  2.94
16  2.909
17  3.11
18  1.82
19  2.94
20  2.94
21  2.94
22  2.94
23  2.94

28  0.00
30  0.00
31  0.00
32  3.11
33  3.11
34  0.22

Off state showed only residual and dropping V readings.

Your pic answers.
tp3 4.99
x1  0.00
x2  0.903
x3  2.941
x4  0.910
x5  1.820

More to follow.

purpose:
Tants

61  17.55
58  1.245
56  2.493
59  20.03
62  18.79
60  8.99
57  9.00
53  8.69
51  9.00
44  4.98
32  2.50
26  2.50
20  4.98
89  8.99
80  1.82
68  1.82
79  2.94
67  2.94
68  1.82
41  2.50
42  3.11
35  3.11

Peter

frenky:
Wow thank you. You are the best! :-+

I'm sure that many (including me of course) will find your effort realy helpful while trying to fix faulty Fluke 287/289. :-DMM

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod