Electronics > Repair
Fluke 289 not quite sorted.
<< < (15/49) > >>
AnJu:
Frenky, I successfully downgraded to 1.1 version but the console works the same way.  |O
What terminal program did you use to access redboot?
frenky:
ExtraPuTTY. http://www.extraputty.com/
So I could upload binary file with xmodem.
AnJu:
Ok I will try connect with ExtraPuTTY.
Also please provide your working script too.
frenky:
I do not have a script.
My fluke is faulty so on boot-up sequence it tries to load OS from ROM/Flash, but it can't find it. (Corrupted memory?)
So it stays in redboot.
But I have read, that if you send Ctrl+C early during boot it will stop booting OS and show redboot console.
AnJu:
Pinout J6 ENET1
1   GND
2   nCS4
3   nEB3
4   nOE
5   GND
6   nRW
7   RESET_IN
8   TIN
9   GND
10   A1
11   A2
12   A3
13   GND
14   D0
15   D1
16   D2
17   GND
18   D3
19   D4
20   GND

Pinout J7 ENET2
1   GND
2   D5
3   D5
4   D7
5   GND
6   D8
7   D9
8   D10
9   GND
10   D11
11   D12
12   D13
13   GND
14   D14
15   D15
16   GND
17   VCC
18   VCC
19   VCC
20   GND
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod