EEVblog Electronics Community Forum
Electronics => Repair => Topic started by: sprit on April 21, 2023, 04:05:03 pm
-
Hi everybody. Have a good day. I have a Fluke 741B Process Calibrator that is experiencing software failures. After trying to adjust the reset pin state, I finally managed to connect it to the computer via rs232. I am looking for software update for this model. i can't load 744 program in my 741B because it only has 2 sram while 744 has 4 (probably the problem is not enough memory). I need your help. Thank you very much everyone.
Sincerely,
Feng