EEVblog Electronics Community Forum

Electronics => Repair => Topic started by: ElektroAlp on January 12, 2021, 05:17:21 pm

Title: Fluke 773 Milliamp Process Clamp Meter Repair
Post by: ElektroAlp on January 12, 2021, 05:17:21 pm

Hello,
I need help to repair a burnt Fluke 773 Milliamp Process Clamp Meter. I bought it as a not working device. I guess previous owner connected the Voltage input to mains or at least something above 30 Volts. It is obvious that i have to change the burnt items. I have already ordered the orange relay: EA2-5NJ NEXEN. I don't know the values of the 5 Components: C454, C216, R252, L7? (I don't read the "7" very good that is on the right of L5), L8 (I don't read the "8" very good that is on the left of L4). Can somebody who has this Fluke 773 measure these capacitors, inductors and the resistor? Or even better will be the Service Manual.
Thanks in advance for any help.

Title: Re: Fluke 773 Milliamp Process Clamp Meter Repair
Post by: srmahaffy on January 08, 2023, 08:09:29 pm

Hi,
I know this post is very old, but wanted to see if you still need help. I just bought a 773 on eBay.