Electronics > Repair

FRsky Rx died - need help identifying SMD component

<< < (4/4)

linux-works:
btw, we're in the middle of a complexity change in ELRS.  they just added some new modes and that kind of confuses a lot, tbh.

dual band (800/900 for one and 2.4ghz for the other) makes things complex and single-band antenna vs dual band antennas.  and switch diversity vs full chipset diversity.  and compat of this new series vs the previous one that was in place for years.

I'm staying with the previous gen of elrs until the new 'gemini' stuff proves itself.  there's enough in the SX chipset that I dont need to add the complexity of the new series.

but some may really need the low freq support (8/900mhz) and for long range planes, that would make sense.  still, that freq is also there on the older elrs SX chips.

005:
Six years ago, I successfully repaired an XR8 with this LDO: XC6201P332PR

Please also check for a burnt trace as shown in this video from RCModelReviews:

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod