Author Topic: Marconi 2955B CRT Issue - Can only see the extreme edges of the Geometry (Read 668 times)

Reprobyte · « **on:** June 13, 2023, 08:57:12 pm »

Edit - Moved to Marconi boards as advised

George Edmonds · « **Reply #1 on:** June 13, 2023, 10:26:08 pm »

Hi

You need to be posting here.

https://groups.io/g/Marconi-Test-Instruments

The Marconi Instruments support group on groups.io

G Edmonds

wasedadoc · « **Reply #2 on:** June 14, 2023, 10:54:47 am »

The vertical scan appears to be upside down. Check vertical sweep generator, vertical output to deflections coils or plates depending on magnetic or electrostatic deflection.

Reprobyte · « **Reply #3 on:** June 14, 2023, 02:04:28 pm »

Quote from: George Edmonds on June 13, 2023, 10:26:08 pm

Hi

You need to be posting here.

https://groups.io/g/Marconi-Test-Instruments

The Marconi Instruments support group on groups.io

G Edmonds

Thanks for the heads up George, I have moved the discussion over there.


EEVblog Main Site	EEVblog on Youtube	EEVblog on Twitter	EEVblog on Facebook	EEVblog on Odysee

EEVblog Electronics Community Forum

Author Topic: Marconi 2955B CRT Issue - Can only see the extreme edges of the Geometry (Read 668 times)

Reprobyte

Marconi 2955B CRT Issue - Can only see the extreme edges of the Geometry

George Edmonds

Re: Marconi 2955B CRT Issue - Can only see the extreme edges of the Geometry

wasedadoc

Re: Marconi 2955B CRT Issue - Can only see the extreme edges of the Geometry

Reprobyte

Re: Marconi 2955B CRT Issue - Can only see the extreme edges of the Geometry

Share me