Electronics > Repair
Gossen Metrawatt 32EL300R30 electronic load - measured values way off
(1/1)
rockwell:
My Gossen electronic load has the problem that the measured values shown on the display are not correct.
I opened the case and hoped that there are some labeled trim pots to adjust the measured values.
So furtunatly I found 9 trim pots, but they are all unlabelled so I don't dare to touch them and mess up all settings.

Does one know how to change this ?
Or even knows if there is a service manual around, I checked google for this but didn't find anything.
bastl_r:

--- Quote from: rockwell on November 30, 2024, 08:22:55 am ---My Gossen electronic load has the problem that the measured values shown on the display are not correct.

--- End quote ---
Are only the displayed values wrong?
So you have to check only the display or ist input.

Edit: OK its a newer one. Forget the displaycheck.
Manual: https://www.gossenmetrawatt.de/en/products/32-el-300-r30

Regards
rockwell:
Yes, the voltage shown on the display is not the same as that on the input leads measured with a DMM.

It's the same device as the Atten ATZ3711A, Array 3711A and Tekpower 3711A.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod