Electronics > Repair

GW GPC-3030 power supply

(1/3) > >>

LA2BPA:
Hi,
I have a GW GPC-3030 power supply. It has three channels, two of them is adjustable (master/slave).
The master channel seems to be working as it should, however the slave channel is not.
The output voltage can't be adjusted, it just stays at 32V whatever i do.

I have checked op-amps, transistors, diodes and potmeters in the regulator circuits.

Any ideas?

Harry_22:
Hi!

Could you attach a photo of PCB. I think I have a similar device.

LA2BPA:
Here is a couple of images of the unit. Frontpanel, main pcb and a bird view.

wraper:
Measure voltages in operation. Start from measuring if potentiometer actually adjusts the voltage on its wiper terminal.

Poroit:
This may help if you don't already have a copy.

Page 5 gives you a Circuit Arrangement.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod