Electronics > Repair

GW-Instek GDS-800 Service Manual

(1/1)

msraya:
Hello!

I have a problem with an Promax OD-581 with vertical chanel accuracy...
This Oscilloscope is a clone of GW-Instek GDS-800 series...
I Only need service manual in order to run the auto cal function that the instrument have.
It uses a BNC in the rear panel to do the AUTOCAL.

But Promax in Spain only do calibrate the instruments if I send It to them..  :-//
So if someone have the Service Manual PDF and send it to me, I will thank You forever  :)

Regards
Manuel

Machlee:
Hello!

I need the same thing. :scared:

tatel:

--- Quote from: msraya on June 08, 2017, 09:28:57 am ---Promax in Spain only do calibrate the instruments if I send It to them..  :-//
So if someone have the Service Manual PDF and send it to me, I will thank You forever  :)

--- End quote ---

You could perhaps contact Promax, they were nice enough to send documentation about a power supply to me.

https://www.eevblog.com/forum/testgear/(rebadged)-promax-fac-364b-power-supply/msg5561753/#msg5561753

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod