Hey everybody, I'm new here and I'm not sure if this is the right place to post this but would anyone happen to know what type of MSOP-10 chip is used on the Hantek IDSO1070A ? It looks to be the charge controller for the li-ion battery but I cannot read the markings on it because it was fried somehow. I think I accidentally made a ground loop and took that chip out. The rest of the scope looks fine it's just that chip I need to replace. I looked at a MCP73833 and a LTC1733 datasheet but I'm not sure if either are those would be the right choice. Thank you for your help!