Electronics > Repair
Heat seal connection repair
(1/1)
varjag:
Hi,

Had anyone ever successfully repaired a heat seal flex cable to LCD connection before? Quick search is not very encouraging.

I have a cable to a small display with contacts on the flex sheared right outside the contact area on perhaps 1/4th of the length. One option as I see it is to push in the cable under just a fraction of mm and to re-heat to establish the bond to existing contacts. Another I guess is to order a new cable, obtain anisotropic adhesive, clean deposited pads on the display and make a new heat seal?

It's possible to order flexi cables naturally but in this application are carbon contacts required? I assume it's some speciality mask and deposit process, is there any vendor not in "call us for a quote" price range doing that?

It's bleak either way so not holding my breath but any hints would be appreciated.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod