| Electronics > Repair |
| Help! Need recovery CD for WinME version of TDS 5054 (FIXED) |
| << < (3/7) > >> |
| blacknoise:
Some days ago i "upgraded" a TDS5104 from HD to SSD. The scopes operating system is Win2k. I still have the HD image (OS+scope application) on my server. The size is about 1.15 GByte and i created it using "Acronis True Image v9.5.8076" If you like to try that leave me a short note - than i put the image on my ftp... Kind regards |
| darron:
So far, no luck. I still have 4 unknown devices in device manager and TekScope won't start because of that. I've installed the drivers put in \Program Files\Tektronix\..., but that was just VISA stuff. The VXIPNP driver looked promising, but it's not the base level device driver. It's possible this older version only works with WinME... or there's some other driver install in a non-obvious place... I'll keep trying for a bit and see if I can figure it out. |
| amyk:
Which of the above firmware packages did you download? ME drivers won't work on 2k, and vice-versa. |
| darron:
I tried the older one first, removed it, then tried the newer one. Neither had any drivers for the main PCI card or what I assume to be the GPIB interface and the front panel. |
| miguelvp:
Did you read the release notes? --- Quote ---General Information ------------------- The TDS5000 software is a collection of software components that must be installed on a TDS5000 Series oscilloscope. When you purchase a new TDS5000 Series oscilloscope, the main Scope Application and Optional Application software (1M-extended memory, 2M-extended memory, 2A-advanced analysis, J1-Jitter and timing analysis, J2-disk drive measurements, JT3-jitter and timing analysis with Rj/Dj and BER estimation, DVD-optical storage analysis, PW2-power analysis and measurements, and USB-USB2.0 compliance test software only) are installed at the factory. Some software packages must be installed separately by the user, such as the GPIB Programmer Guide or the Performance Verification software. Refer to the booklet that accompanies each Product Software CD for descriptions and instructions to use their contents or contact your local Tektronix representative. The software is on two distinct CD-ROMs: TDS5000 Series Operating System Restore CD and TDS5000 Series Product Software CD. The release supports English only. To update the instrument software to a newer version than was shipped with the oscilloscope, see the instructions included with the TDS5000 Series Product Software CD. The oscilloscope is supplied with the following paper documents in English, unless noted otherwise: User Manual Quick Reference (in ten languages) Graphical Packing List Oscilloscope Analysis and Connectivity Made Easy (User Manuals for Options J1, J2, JT3, DVD, PW2, USB application software packages, if you ordered them.) Optional Application Software Installation Manual TDSUSB2 Reference Card --- End quote --- Look for where they are at in there or ask Tek about the location of those missing bits. |
| Navigation |
| Message Index |
| Next page |
| Previous page |