EEVblog Electronics Community Forum

Electronics => Repair => Topic started by: Rafael on May 17, 2017, 12:54:46 am

Title: Help - Fluke 8200A
Post by: Rafael on May 17, 2017, 12:54:46 am
Hello,

Please, can anyone share any documentation of the Fluke 8200A? I have one, I can power on and light the tubes but read no measurements. Stuck in zeros...

Or any tips on where to start?

Thanks!
Title: Re: Help - Fluke 8200A
Post by: ElektronikLabor on May 18, 2017, 05:53:47 am
It's an old meter; maybe checking for broken solder joints could help?
Title: Re: Help - Fluke 8200A
Post by: dundee on May 18, 2017, 07:23:44 am
Try to clean the switches.
They are often coroded.
Title: Re: Help - Fluke 8200A
Post by: Rafael on May 18, 2017, 11:01:02 pm
Well guys, thanks a lot for the tips...

The switches and joints were cleaned. I have -15999 in VDC, MVC shows a blink digit, VAC donĀ“t show any digit, OHMs switches are keeping the digits in -15999 too... When pressed AUTO, all digits are off now...

For me, RIP voltmeter... :(

Hard to find a good one...

Thanks!