Electronics > Repair
Help identify glass encapsulated diodes
<< < (6/9) > >>
fzabkar:
You can have some confidence in your decoding of the part markings if the datasheets for Q23 and Q24 indicate that they are complementary PNP and NPN BJTs.
晓看风云:

--- Quote from: Kim Christensen on August 26, 2024, 06:12:52 pm ---That's the problem with surface mount components. XL can mean many things.

--- End quote ---
(I'm sorry that the code Q23 misled you, and I sincerely apologize again!) Yes, it's strange that when I removed XL from the circuit board, the diode characteristics between pins 1 and 2 still fluctuated like 0.06-0.08. But when I measured them again after a while, they changed to 0.300-0.500 occasionally, which is a strange phenomenon. I searched everywhere, and only 2SD2704K meets the criteria. I have already ordered it, and I will not rashly install them on the circuit board until I am completely sure that 2SD2704K is the correct model. Acting rashly will only lead to the expansion of the malfunction, which is not what I want to see!
晓看风云:

--- Quote from: fzabkar on August 26, 2024, 06:19:27 pm ---You can have some confidence in your decoding of the part markings if the datasheets for Q23 and Q24 indicate that they are complementary PNP and NPN BJTs.

--- End quote ---
You can take a look at my other latest reply messages. I am very sorry for the inconvenience caused by the code Q23. The component of the silk screen XL is not included in the circuit diagram I provided, it is located elsewhere. I haven't found any problems with the circuit around LT1007 so far. I won't find any problems here for the time being. I will go to other places to seek the fault phenomenon, such as this XL screen printed switch transistor calibrated with Q!
Kim Christensen:
Hmmm... It could be a MOSFET. If you leave the gate floating and do a diode check between drain and source, you will get readings that drift. Shorting the gate to the source will make the drain-source measure open, or as a diode if measured in reverse.
fzabkar:
The mark might be "KL" ...
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod