Help identifying and locating resistor

[buckwheat]

I am trying to identify this device (WSR-2). From my research, I believe it is a current sensing resistor. It is on a Magneti-Marelli ECU last produced around 2000. Any help is appreciated!

[mariush]

If it's same as the other on the right, it's Dale WSR-2 series resistor , 0.649 ohm 1%

wsr datasheet : https://www.vishay.com/docs/30101/wsr.pdf

marking  : https://www.vishay.com/docs/30327/pms-pmpmarking.pdf

2 is most likely 2w rating

[buckwheat]

Thanks for that, I ordered a replacement and I'm going to attempt the repair. Do you know what coating would be applied over the top of this? I can't tell if it is a spray or brush on, it has a tacky feel to it.

[mariush]

No idea, but you should also figure out why it blew in the first place .. check for shorted mosfets, diodes that are open both ways etc

[wasedadoc]

No idea, but you should also figure out why it blew in the first place .. check for shorted mosfets, diodes that are open both ways etc

+1.  There has been a lot of current through that resistor.  It didn't just fail all by itself.