Electronics > Repair
Help Identifying Fuse Type
Harry_22:
Review elements at the Gate. If the track goes directly to the PFC controller via resistor, then it needs to be replaced.
If you want to check, then unsolder this transistor, apply DC from 50V instead of mains and watch the gate with an oscilloscope.
Check that it is PFC, otherwise anything can happen.
Be careful. There will be 400V at bulky capacitor!
tooki:
--- Quote from: Harry_22 on November 30, 2024, 02:31:31 pm ---
--- Quote from: coromonadalix on November 30, 2024, 12:16:34 pm ---depends if it was a slow or fast blow
--- End quote ---
It is universal :)
--- End quote ---
There is no such thing as a universal fuse. ;)
Navigation
[0] Message Index
[*] Previous page
Go to full version