EEVblog Electronics Community Forum

Electronics => Repair => Topic started by: giosif on December 14, 2020, 08:14:33 pm

Title: Help trace what the IC is connected to in a Gossen Metrahit X-TRA / Pro
Post by: giosif on December 14, 2020, 08:14:33 pm

Hi,

Apologies for the duplicate, but I thought I'd ask this explicitly, in case people are not following my other Gossen repair thread: could someone with a Metrahit X-TRA or Pro be so kind to check where the traces for the two IC pins in the green rectangle are going?

Thank you!

Title: Re: Help trace what the IC is connected to in a Gossen Metrahit X-TRA / Pro
Post by: giosif on December 18, 2020, 03:33:50 pm

Anyone, please?

Title: Re: Help trace what the IC is connected to in a Gossen Metrahit X-TRA / Pro
Post by: Florian68 on December 18, 2020, 09:10:46 pm

Maybe it helps you

Title: Re: Help trace what the IC is connected to in a Gossen Metrahit X-TRA / Pro
Post by: giosif on December 18, 2020, 09:59:20 pm

Many thanks!
Ok, so those two pins don't go to the customer ADC IC, but to the unpopulated section on the board (probably populated for a different model).