Electronics > Repair
Help with dead AT PC Power Supply
<< < (4/11) > >>
naujoks:
I'm getting 370V at the capacitor.
I will proceed to test the other lines.
Harry_22:
Always remember that the high-tension capacitor needs time to discharge. Especially in non-working PS units!
Monitor it with a voltmeter.
Harry_22:
Check also C8 for short by multimeter.

PS
There is some high voltage in your mains as much as 260 VAC!
naujoks:
Yes, thank you. The capacitor discharges quite quickly by itself.
naujoks:
I measured all the rails, and I'm getting the correct power output on all of them.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod