Electronics > Repair
Help with dead AT PC Power Supply
naujoks:
Ok, I used IPA on the PCB and touched it, but nothing is getting warm.
The bench PSU draws only 0.031A.
Harry_22:
Increase the voltage step by step to get 1W consumption. Maximum limit is 12V.
naujoks:
Ok, the biggest IC on the board is getting warm.
Harry_22:
This is PWM controller itself. Probably internal zener diode is broken.
Try cleaning the black stuff off the chip top to clarify its name.
naujoks:
Ahhh I was hoping the black stuff is some kind of plastic shrink warp, but the material is almost like the body of an IC.
I tried to scrape it off, but the model number of the IC came off as well. I thought I could see "A23", but no guarantee, and it isn't much to go by :(
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version