Electronics > Repair
Help with dead AT PC Power Supply
<< < (10/11) > >>
Harry_22:
Good.
Please measure resistance between pins 8 and 4 of PWM.

Double check that pin 8 PWM is connected to pin 4 of optocoupler.
naujoks:
The resistance between pin 4 and 8 on the PWM is 12k Ohm.
There really is no continuity between PWM pin 8 and optocoupler pin 4.
Harry_22:

--- Quote from: naujoks on October 09, 2024, 12:36:50 pm ---Pin 4 of the opto coupler is connected to pin 6/7 on the board (pin 8 of the PWM).

--- End quote ---

--- Quote from: naujoks on October 09, 2024, 07:55:19 pm ---There really is no continuity between PWM pin 8 and optocoupler pin 4.

--- End quote ---
What pin of opto coupler is connected to pin 8 of PWM?

Please send a photo with ะก10 marking.
naujoks:
Pin 8 of the PWM is connected to pin 5 of the optocoupler.
Harry_22:

--- Quote from: naujoks on October 09, 2024, 09:43:10 pm ---Pin 8 of the PWM is connected to pin 5 of the optocoupler.

--- End quote ---

Much better!
Please measure the capacitance of C10.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod