| Electronics > Repair |
| Help,Can ordinary LEDs replace thin-film LEDs? |
| << < (3/7) > >> |
| Phil1977:
Do you really want to solder and place over 140 LEDs there? If yes, I´d try to find out if you can modify the supply voltages of the high voltage driver ICs to LED compatible levels. |
| daisizhou:
If placing LEDs is feasible I will proceed with the plan. I don't know if the electrical performance of EL is compatible if I change it to LED, because I am not familiar with EL components. www.scribd.com/document/249426163/Manual-e100m-Serman-Rev-d-2202 Page 104 has the schematic diagram of the display part thanks |
| Phil1977:
I can't download the manual (registration required) but as I had a quick look over the datasheet pages, I wonder if it´s possible to reduce "V_pp" to let´s say 5V and connect LEDs to the outputs. The max current of 0.5mA is not very much, but may be sufficient for a bright display. You could test it with a few wired LEDs that get patched to the headers. |
| squadchannel:
Schematic downloaded. Attached. :-+ |
| squadchannel:
with... |
| Navigation |
| Message Index |
| Next page |
| Previous page |