Electronics > Repair
Hioki 3532-50 LCR Repair (One major problem solved, SM still wanted)
<< < (24/34) > >>
Martin72:
A circuit diagram would be helpful, try your luck with the supplier...
I'm a bit surprised at the moment that it's such a “problem” to display the characters properly.
KungFuJosh:
I was surprised at first as well, but I'm not anymore. Hioki clearly designed it a specific way with a specific LCD panel, and getting a modern LCD to match that isn't as straight forward as I thought. At least not for whatever this LCD was designed for.

I already asked for a schematic and they said they didn't have one. Which might might mean "they don't have one they'll share." 🤷
coromonadalix:
all theses resistors things must play with duty cycle, timings  etc ...   it's a matter of finding the row and column drivers data sheet if they exists and try to figure out   ...
KungFuJosh:

--- Quote from: coromonadalix on August 26, 2024, 10:48:34 pm ---all theses resistors things must play with duty cycle, timings  etc ...   it's a matter of finding the row and column drivers data sheet if they exists and try to figure out   ...

--- End quote ---

Exactly. Here's my notes so far:

R1 392 -> 4.7k -> 5.6k (increase shifted contrast center further after adjusting R2)
R2 472 -> 7.5k (better contrast center / more range with trim pot)
R3 823 -> 100k
R4 622 -> 7.5k -> 10k (bad - more flicker) -> 5.6k (less flicker)
R5 392 -> 4.7k -> 5.6k (vertical lines partially returned) -> 7.5k better!
R6 822 -> 10k
KungFuJosh:
I just ordered another touch panel from eBay (already got a refund from the junk one). This one is supposedly new, and the trace pattern looks more like the original.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod