Electronics > Repair
Hioki 3532-50 LCR Repair (One major problem solved, SM still wanted)
KungFuJosh:
R5 at 5.1k is definitely better.
Now I should go to bed 2 hours ago. 😬
coromonadalix:
the best results so far
TERRA Operative:
You almost need a breakout board like a mini 'mixing desk' of trimpots to tweak and dial them in to get it perfect, then substitute with the closest fixed values. :-DD
coromonadalix:
loll yep had the same toughts .... but i would say somewhat usable like this ... depends of the OP loll
seems a bit weak in the lower corners ?
@KungFu can you show us the chip markings for the row and column drivers ? u9 u10 u11 too ?
KungFuJosh:
--- Quote from: coromonadalix on August 28, 2024, 12:52:08 pm ---loll yep had the same toughts .... but i would say somewhat usable like this ... depends of the OP loll
seems a bit weak in the lower corners ?
@KungFu can you show us the chip markings for the row and column drivers ? u9 u10 u11 too ?
--- End quote ---
A pot doesn't work in every position. R1 was okay, R6 did nothing, and I think R5 hated not being a fixed value for some reason. 🤷
I definitely think it's easily usable now, but I might try 5.6k in R5 as R5 seems to directly affect those corners. My only concern is that it might cause some more ghosting. I also think it looks better in person than in the photos.
In reply #110 above, there's a high resolution attachment you should be able to view the chip markings on (the one with the -min suffix).
Thanks,
Josh
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version