Electronics > Repair
Hioki 3532-50 LCR Repair (One major problem solved, SM still wanted)
<< < (34/34)
Martin72:
That looks very good now. :-+
Are you going to leave it as it is and deal with the device itself?
KungFuJosh:
Thank you, yes, it's great as it is.

It's got the internal contrast control (I swapped with a 10k as it was supposed to be). I doubt it should need to be adjusted with this LCD panel anyway. I tried contacting the manufacturer of the original pot, but never heard back. From the pot case to the end of the shaft is 35mm, and I couldn't find anything that is both a 9mm pot and that long. So I'm over that. I used some double-sided tape to mount the knob so it doesn't look goofy. Another option was to put something goofier there, but I opted not to since I'm not gonna keep it.

It's already warmed up, so I'm doing open/short correction now and I'll see how it compares with the LCR Cal Test PCB. I'll post the results in that thread when I'm done.

Thanks,
Josh
KungFuJosh:
Here's a couple more photos. The screen zoom feature is cute. I posted the test results in the Cal Test PCB thread.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod