Electronics > Repair
HM8030-3
<< < (5/7) > >>
oldway:

--- Quote from: anotherlin on May 19, 2018, 01:38:42 pm ---
--- Quote from: oldway on May 19, 2018, 12:54:54 pm ---Please read the whole topic before posting such bullshit.
[...]
It's really a shame when I provided the solution to the problem.  |O  :box: :box:

About relevance of my posts, I will not answer because you are trolling and I don't want to feed your trol.

--- End quote ---

Maybe you should calm down a bit.

As I said before, the HM8030-3 may have more in common with the HM8030-4 than the HM8030-2.
The 8030-3 may have been improved in the meantime.
Without a specific "adjustement" manual for the HM8030-3, it is difficult to find where are the "adjustment" trimmers on the board.

Have a look to the PCBs of the 8030-2 vs. 8030-3, they are very different :

https://www.radiomuseum.org/r/hameg_funktionsgenerator_hm8030_2.html
https://www.radiomuseum.org/r/hameg_funktionsgenerator_hm8030.html

--- End quote ---

Can't you understand that this is not the problem ?  |O

lionelkjh has already the manual of the HM8030-3 with boards, schematics and adjustment procedures.....  :phew:   But he is not satisfied with that, he want its complete calibration (by potentiometers).

https://www.eevblog.com/forum/repair/hameg-hm8030-3-hameg-hm8011-3/
anotherlin:

--- Quote from: oldway on May 19, 2018, 04:39:19 pm ---lionelkjh has already the manual of the HM8030-3 with boards, schematics and adjustment procedures.....

--- End quote ---

Then it would be great to post them.
Currently the only manual for the HM8030-3 that can be found online, is a user manual with some functionnal tests.
oldway:

--- Quote from: anotherlin on May 19, 2018, 08:47:17 pm ---
--- Quote from: oldway on May 19, 2018, 04:39:19 pm ---lionelkjh has already the manual of the HM8030-3 with boards, schematics and adjustment procedures.....

--- End quote ---

Then it would be great to post them.
Currently the only manual for the HM8030-3 that can be found online, is a user manual with some functionnal tests.

--- End quote ---
He did not get them online, he asked for them and obtained directly from HAMEG.

Someone already asked him to post them, he did not answer.
lionelkjh:
Hello everyone! Finally I found the solution: thanks again!
shakalnokturn:
Always asking and never giving only lasts a while, especially once people realise you're making cash on the repairs.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod