Electronics > Repair
HM8030-3
<< < (6/7) > >>
lionelkjh:
I do not remove anything from my repairs, since it is for my workshop, so for a strictly personal use !! We must stop to say any betise when we do not know anything about people!
oldway:

--- Quote from: lionelkjh on May 25, 2018, 04:17:46 pm ---Hello everyone! Finally I found the solution: thanks again!

--- End quote ---
What was this solution ?
shakalnokturn:
It's a secret!
RANKZER0:
Hi All,

Stumbled across this thread, as I had brought a second hand HM8030-3 a while back and finally had a use for it (Tube amp) and I realised it was completely out of calibration. Based on the post from coromonadalix, I was able to figure out how to adjust it. While it's 5years later, does anyone still need to know? As I found it was pretty frustrating that I could fine no information on calibrating this model.
Kikokiri:
I recently got one of these second hand as well, and I'd love some advice on how to calibrate it
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod