Electronics > Repair
How To: Make a new boot disk for your HP 4145B Semiconductor Parameter Analyzer.
<< < (5/5)
TERRA Operative:
I would check and adjust the power rails as a first step, the golden rule of troubleshooting... Thou shalt check voltages!  :-DMM
RikV:
I did that as soon as I had the opportunity. Right at that moment that was not the case. Anyhow, all voltages were in spec at the time of verification. As I said: the red LEDs are misleading (me), they should be green since they indicate an OK situation.
I did some measurements and all SMUs seem operational and rather on spot. Full calibration, starting with the 1345A, to be done (this will take a lot of time I guess).

BTW, my 4148B is missing the plastic parts (front bezel and button) of the FDD. Anyone who happens to have the necessary 3D files to print them?
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod