Electronics > Repair
How to open an OCXO?
jadew:
Hey guys,
I'm trying to open an OCXO and I have very little success. I even tried heating it up with hot air and then using a desoldering station to suck up the solder, but it just wouldn't melt properly.
Tried adding more solder, heating it up + desoldering gun - no success either.
Any suggestions? I'd like to stay away from the oven so I preserve the sticker on the front.
Thanks.
eurofox:
--- Quote from: jadew on July 14, 2014, 01:21:40 pm ---Hey guys,
I'm trying to open an OCXO and I have very little success. I even tried heating it up with hot air and then using a desoldering station to suck up the solder, but it just wouldn't melt properly.
Tried adding more solder, heating it up + desoldering gun - no success either.
Any suggestions? I'd like to stay away from the oven so I preserve the sticker on the front.
Thanks.
--- End quote ---
:-DD :-DD :-DD
jadew:
haha, good one!
edpalmer42:
We need to see a picture before we can give you any reasonable suggestions. Of course, if you want unreasonable ideas ....... :)
Ed
KJDS:
Use an axe.
It's possible that it's been laser welded, or soldered with a high temperature solder, or is just too big a heatsink for your hot air gun, therefore the only sensible solution is an axe.
Navigation
[0] Message Index
[#] Next page
Go to full version