EEVblog Electronics Community Forum
Electronics => Repair => Topic started by: calibrationfixture on January 18, 2025, 02:06:10 pm
-
Hi to All,
Contrary to the 5V Versions, my Batronix Programmer doesn't cover these 3.3V Versions. I could lower the Vcc with two Diodes in series and make the Vcc connection out of the ZIF-Socket. A legitimate solution? Thanks in advance for any insights.
Calibrationfixture
-
No. The datasheet says:
ABSOLUTE MAXIMUM RATINGS
Voltage on Any Pin Relative to Ground -0.3V to +4.6V
which means the address, data and control pins are *NOT* 5V tolerant. If the programmer is using 5V Vcc with CMOS thresholds, it will overdrive the Dallas DS1245W pins.
-
@calibration
there was no need to restart a thread about your equipment, your diluting the subject into many parts, many are doing this nowadays and it get really annoying to follow
just find a programmer for it
TL866A or CS, TL866II, Xeltec and others can do it, arduinos projects can do some of them etc ...
-
No. The datasheet says:
ABSOLUTE MAXIMUM RATINGS
Voltage on Any Pin Relative to Ground -0.3V to +4.6V
which means the address, data and control pins are *NOT* 5V tolerant. If the programmer is using 5V Vcc with CMOS thresholds, it will overdrive the Dallas DS1245W pins.
If you have the time, it's fairly easy to construct a DIY bi-directional voltage level shifter:
[attachimg=1]
-
True, but will a simple discrete MOSFET level shifter be fast enough for a programmer running a RAM chip definition, that wont have any extra delays?
Its probably easier to breadboard a dedicated 'burner' using any 3.3V Arduino with enough I/Os.