Electronics > Repair

How to Program a Dallas DS1245W? This is a 3.3V Device.

(1/1)

calibrationfixture:
Hi to All,

Contrary to the 5V Versions, my Batronix Programmer doesn't cover these 3.3V Versions. I could lower the Vcc with two Diodes in series and make the Vcc connection out of the ZIF-Socket. A legitimate solution? Thanks in advance for any insights.

Calibrationfixture

Ian.M:
No.  The datasheet says:

--- Quote ---ABSOLUTE MAXIMUM RATINGS
Voltage on Any Pin Relative to Ground -0.3V to +4.6V

--- End quote ---
which means the address, data and control pins are *NOT* 5V tolerant.   If the programmer is using 5V Vcc with CMOS thresholds, it will overdrive the Dallas DS1245W pins.

coromonadalix:
@calibration

there was no need to restart a thread about your equipment,    your diluting the subject into many parts,   many are doing this nowadays  and it get really annoying to follow

just find a programmer for it

TL866A or CS,  TL866II,  Xeltec and others can do it,  arduinos projects can do some of them etc ...

DonKu:

--- Quote from: Ian.M on January 18, 2025, 03:00:24 pm ---No.  The datasheet says:

--- Quote ---ABSOLUTE MAXIMUM RATINGS
Voltage on Any Pin Relative to Ground -0.3V to +4.6V

--- End quote ---
which means the address, data and control pins are *NOT* 5V tolerant.   If the programmer is using 5V Vcc with CMOS thresholds, it will overdrive the Dallas DS1245W pins.

--- End quote ---

If you have the time, it's fairly easy to construct a DIY bi-directional voltage level shifter:

Ian.M:
True, but will a simple discrete MOSFET level shifter be fast enough for a programmer running a RAM chip definition, that wont have any extra delays?

Its probably easier to breadboard a dedicated 'burner' using any 3.3V Arduino with enough I/Os.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod