Electronics > Repair
HP 34401 probe fits very tightly
tkamiya:
Hi.....
I have something like 8 HP 34401 (not all of them are mine) and third-party probes. All of them fit very tightly/snugly into terminals on 34401. That is, as if outer diameter of the insulation on banana plug is too large. Is this the way they fit? I don't own a genuine probe by HP. Some of them are just tight, but most of them are so tight, they are hard to pull them out. What I have are eBay specials.
Have anyone experienced this?
TheSteve:
I think you need better quality probes :)
Wallace Gasiewicz:
Usually mine are too loose HA!
Sometimes a little white thermo grease (for mounting transistors on a heat sink) helps. Just a little. I know it is not conductive but does not matter.
Wally
tkamiya:
You mean to say eBay probes aren't quality? Ad said "made of high grade material in China." Supposedly they are compatible with HP, fluke, Agilent, etc, etc, etc :-DD
Hamelec:
..had the same Issue.
Used a reamer to fix it 10 Years ago.
See Service Note as attached.
Navigation
[0] Message Index
[#] Next page
Go to full version