Electronics > Repair
HP 34401a DMM with leaking segments
<< < (20/45) > >>
qu1ck:
Yeah, only ground plane pads got affected and only 2 of the 4.  :-//
Fret not, some elbow grease and good microscope to the rescue:







Also had some fun with recording video. I just might record the whole assembly process too.

https://youtu.be/ZoB_NMqq5YA
bitseeker:
Looks good, qu1ck. If you record the assembly, I'll watch. :-+
qu1ck:
I'm waiting on couple parts to arrive before I start the build. But in the meantime I published the Kicad BOM plugin I showed earlier.

Github

Better than earlier demo

Started a thread for it in KiCad section https://www.eevblog.com/forum/kicad/interactive-html-bom-plugin/
hillflyer:
How about displaying the 1 or 2 extra digits that are available via GPIB or RS232?
Samogon:

--- Quote from: hillflyer on July 27, 2018, 02:10:45 pm ---How about displaying the 1 or 2 extra digits that are available via GPIB or RS232?

--- End quote ---
Since he is getting data given to front panel i think it is not possible.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod