« previous next »
Pages: [1]   Go Down

Author Topic: HP 410C  (Read 455 times)

0 Members and 1 Guest are viewing this topic.

Offline wd5jfrTopic starter

  • Regular Contributor
  • *
  • Posts: 144
  • Country: us
HP 410C
« on: June 05, 2023, 09:48:17 pm »
Got a solid state one with no red paint on the low AC meter scale.  Not sure if it's original or been upgraded to SS because it  has the  A3 0041066502 Rev E 88809F PC board.  My  410C serial No. 098A214826 and my manual is for 0982A22439. I'm having difficulty calibrating 0.5 VAC and can't find anything in my manual which refers to adjusting A8R8 ZERO ADJ  on rear of cabinet.  Any suggestions or info appreciated.
Hank
Logged
 

Offline m k

  • Super Contributor
  • ***
  • Posts: 1995
  • Country: fi
Re: HP 410C
« Reply #1 on: June 12, 2023, 02:43:19 pm »
I'm reading HP Archive manual 01556-5 from Sep-68.
Its 5-11 a. has a ZERO ADJ for DCV accuracy check.
Seems that it is a dynamic thing and for the moment.

For 0.5 VAC,
are you doing the AC voltmeter calibration?
(page 39/68 of above manual)
Logged
Advance-Aneng-Appa-AVO-Data Tech-Fluke-General Radio-H. W. Sullivan-Heathkit-HP-Kaise-Kyoritsu-Leeds & Northrup-Mastech-REO-Simpson-Sinclair-Tektronix-Triplett-YFE
(plus lesser brands from the work shop of the world)
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee