Electronics > Repair
HP 53310A - Power supply troubles
<< < (7/7)
Tomorokoshi:
I used an Agilent U1732B handheld LCR for most measurements. I used an HP 4194A impedance analyzer to check the U1732B and to measure extended frequency ranges. I marked all the parts I removed so I can run a full frequency sweep if needed. C19 and C37 were probably the cause of shutdown, but most of the 1000uF, 35V parts had some leaking.
Davidthanam:
Hi,
it would be nice if you provide the detail of C43 cap value?
It's a hard time, it burned out, i need to fix it out.
please help me in this regards
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod