yes the voltages on the big connecter that goes to the mailboard are as follows,factory recomended voltages first followed by my readings,this is with a 2 ohm load between the +5.2v rail and ground,
pin1+5.2v,mine+2.8v
pin2+5.2v mine+2.85v
pin3+5.2v,mine+2.86v
pin4+5.2v,mine+2.86v
pin5,gnd,mine gnd
pin6,gnd,mine gnd
pin7,gnd,mine gnd
pin8,gnd,mine gnd
pin9,+3.5v,mine +0.4v
pin 10,gnd,mine gnd
pin 11-5.2v,mine +0.6v
pin12,gnd,mine gnd
pin 13+12v,mine +9.1v
pin 14,gnd,mine gnd
pin 15 -12v,mine -2.7v
pin 16,gnd,mine gnd
pin 17+12v,mine,+0.52v
pin 18-5.2v,mine,+12v,mine,+0.58v
pin 19+15.5v,mine +0.65v
pin 20+5v,mine+0.04v
also measured the tip l755a as oscillating at 160hz on the transformer primary.,not sure where to go with this.