Electronics > Repair
HP 54810A
<< < (4/4)
GGMM:
Hello,

Unmounted acquisition board
Not much time to find the culprit.
Capacitor removed and board cleaned, no more short circuit.
I will replace it and make the change for acquisition at 2GB/s. I think it is necessary to put a resistance 0 ohm on r154 I think.
Under reservation that nothing else burn....
cdt
GGMM:
See this link to pass at 2GO/s
https://www.eevblog.com/forum/repair/agilent-54810a-infinium-o_scope-possible-updates/

But it’s not clear yet.
It is R134 and not R154 (sorry)  that must be set to 0 Ohm
On the example R137 seems desoldered, on my board there are 0 Ohm, so the explanation is not clear.
Should we:
1st Delete R137
2nd Set 0 OHM to R134.
I’ll see later, because it’s accessible without the cover

cdt
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod