Electronics > Repair

HP/Agilent/Keysight Switching Power Supply Controller Repair

<< < (4/4)

ZGoode:
Well, I have finally received my boards from JLCPCB and I can confirm that my reverse engineered design does work.  I got the power supply to turn on and successfully calibrated the rails within the specs listed in the manual.  Within the week I will clean up the schematics and give a list fo the values I ordered on DigiKey for anyone who might need this in the future.

sevarre:
WOW, ZGoode, this is amazing. Thanks for all the work you put in to this.

I am working on an HP 4194A and suspect my 1813-0255 is bad. This "chip" is used on the A2 board of the 4194A and 4195A (04194-66502). I am going to build a board with the files you provided in Reply #10 and let you know how it goes.

Again, THANKS FOR THIS!

ZGoode:
I'm so happy this will benefit you!
The gerber files in reply #10 are good to go.  I'll add an excel file of the parts I ordered on Digikey for you when I get off work.  I used all 0.1% or lower resistors which are probably overkill, but I really didn't want to play around with values so I just used as close as I could find to the readings on my 7510.  Plus the 0.1% resistors were actually not really that expensive anyways

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod