Identify ic of ELTEK board multicharger 1500

[HUGOMAN]

Hi
I have this exploded ic I couldn’t identify, can you see this? thanks.

[fzabkar]

Could it be a TNYxxx from Power Integrations?

[max.wwwang]

Could it be a TNYxxx from Power Integrations?

I suspect that is probably the case -- a part of the flyback converter power supply. The remaining part of the logo looks like that of PI.

Recently replaced one of these bad boys on a cloth drier control board. Check if it has only 7 legs.

[HUGOMAN]

Sure it's a power ic switch but since it is exploded i can't know exactly what reference series, i guess Top223 or 224! Unless if there is photo of this board. 

[HUGOMAN]

I check now TNY series
TNY266 P or G10 W15 W6 W9.5 W
TNY267 P or G13 W19 W8 W12 W
TNY268 P or G16 W23 W10 W15 W
maybe I will try TNY268!

[fzabkar]

I think the TOPxxx parts are a better fit.

Can you find the missing piece of the IC inside the case?

[HUGOMAN]

Thanks Mr  Fzabkar
I did not think about thank you, i hope i can find this piece part inside the charger!

Regards

[gamalot]

I think the TOPxxx parts are a better fit.

Can you find the missing piece of the IC inside the case?

Could it be TOP242-250G ?

https://datasheetspdf.com/pdf-file/1487931/PowerIntegrations/TOP246/1

[fzabkar]

Could it be TOP242-250G ?

https://datasheetspdf.com/pdf-file/1487931/PowerIntegrations/TOP246/1

Looks good electrically and physically.

https://i.ebayimg.com/images/g/LDYAAOSw8elgticH/s-l500.png

[HUGOMAN]

  Thanks Fzabkar  , i will let you know.

[HUGOMAN]

Hello
Thank you Mr Fzabkar. I found in my stock parts the TOP244pn. I removed up the exploded one and I put this top244 works perfectly. But unfortunately there is no voltage in output even I reload factory parameters, so no output voltage!