Electronics > Repair
IT7321 AC Power Source no Voltage on the Output
(1/3) > >>
derZockerMP:
Hello, I yust recived a ITech Programmable Voltage Source in a good outer shape. It starts perfectly and Voltage and Frequenzy can be selected. But then I turn on the Output, no Voltage is present. Did I made a mistake by the entry of some Values or is it a defect of the Source? The Voltage Reading of the Instrument stays also around 0V. Can sombody help?
derZockerMP:
Here some pictures
Harry_22:
Hi!

Try to initialize system menu.
derZockerMP:
Hello, the initialisation yust went finde. But the Issue is still there. But thanks for the help.
Harry_22:
Set up the lowest output voltage, switch output on, check that voltage is missing. After that try to provide for instance 1VDC from external supplier and watch the voltmeter readings.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod