Electronics > Repair
JABE UD-1200 JBC clone soldering station does not heat up
<< < (3/3)
snoopy:

--- Quote from: Swake on January 02, 2025, 10:49:44 am ---Good find.  :-+
That track worked as a fuse, sounds like a good place to put a real fuse as it happened during tip change.

--- End quote ---

ironically the circuit appears to have some sort of current limit by measuring the voltage across a 5 milliohm resistor and feeding this information to the micro but obviously the current limiting is more than the trace can handle.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod