Electronics > Repair

JCD 8898 IC shorted

<< < (3/3)

DavidAlfa:
It's a mcu, so replacing it won't make it work, must be programmed, I doubt you could do that easily, nor getting the original firmware.

At this point, just get a new station, or try to find a new board.

GGMM:
Hello,

I don’t quite understand your breakdown.
You say a short circuit, but on what?
Is it on the mains? Is it all blown up and the fuse?
I don’t see this circuit blowing the power.
When you say the iron worked and not the hot air, was there the temperature indication of the soldering iron?

Etc...
cdt

Navigation

[0] Message Index

[*] Previous page