Electronics > Repair
JDSU JD745A / GC747a Base Station Analyzer - Repair log
<< < (4/5) > >>
Qw3rtzuiop:

--- Quote from: suj on May 17, 2021, 08:35:26 am ---I'm not sure but maybe it was some PCB stress or problem with the N/SMA connector at the input of the spectrum analyzer?

--- End quote ---

Hopefully your problem wont appear again.

I found a cracked mlcc at the IF path that caused some losses of my unit.
pieroandreini:
Making a pendrive with the recovery files you share seems don't work on my J745A with firmware 3.120.043
Which version should I install? May I make a downgrade safely?
Qw3rtzuiop:

--- Quote from: pieroandreini on February 11, 2023, 06:49:08 pm ---Making a pendrive with the recovery files you share seems don't work on my J745A with firmware 3.120.043
Which version should I install? May I make a downgrade safely?

--- End quote ---

Hi i used the latest firmware 1.122.000. The 3.120.043 is the latest firmware for the newer B model.
HF-Bastler:
I have the same machine since 2 weeks and the problem seems to be the same. In analyzer mode there is a loss of 10-40dB. I checked the mixer-board and everything seems to be fine. Did you solve your problem with a new calibration table or replacing the mmic? Which mmic was damaged?
HF-Bastler:
Here is the plot of my frequcal.dat, it looks like it's fine. No idea which component is broken
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod