I make some investigations.
There is some measurements, 2 chips marked with RED getting really hot
.
Scopes boot to measurements screen with error message:
"software failure,PLL unlock, uncalibrated, defaults loaded"
Also it do not feed 5V to USB HOST connectors (can't read usb), but
when i plug it to PC its find a new device..
U1809 - oscillator powered, but tuned off state (worked, tested)
U2901 74act04 Hex Inverter getting very hot
U2520 act11374 Octal D-Type Edge-Triggered Flip-Flop getting very hot too
500Mhz VCO generator module itself seems to start
but ACQ chips (5 pcs) do not start (no oscillations on pins some have log"1", some log"0")