Electronics > Repair
Korad KA3005P power supply faulty/repair
<< < (14/27) > >>
pomonabill221:
Wonder if the firmware is the same for all the models?  For instance, if you were to populate the I/O board, would the supply recognize commands?
If it isn't alot of trouble, might be worth trying it out!
commongrounder:
Yes, I'm curious about the firmware compatibility, as well.  If I can ID the parts, I might try it just to see what would happen.  It would be fairly low risk and wouldn't take much time to set up.  I could also see how much the I/O board would cost as a part and just swap it out.
pomonabill221:
Here are some pics of the I/O board.
commongrounder:
Fantastic, pomonabill221!   ;D  Thank you very much for taking the time to do this.  I will study these and see if I can come up with a parts list for completing an I/O mod for a non-USB/RS-232 Korad.
commongrounder:
Okay.  I studied pomonabill221's photos and pulled my board.  Surprise!  :palm:  The boards are not the same...  I am assuming there is either more than one version of this board, or there is a board designed specifically for the KA300xD or P-3S triple output supplies.  I've attached a photo of my board.  If anyone has a "P" version of the triple output supply with the populated I/O board they feel like sharing a photo of, I will research the missing parts.  Thanks!
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod