Electronics > Repair
Korg Electribe ER-1 mkII repair
<< < (3/6) > >>
james_s:
I wonder if they revised it and added a diode? Or maybe they were a different model, but I know they were Korg Electribe devices. Pretty sure the ones I fixed didn't have a protection diode but perhaps they did and it was overvoltage that zapped them.
feedback.loop:
It works!



The firmware is attached.
james_s:
Awesome! Nice job!

So it turned out to be the MCU and DSP?
feedback.loop:
DSP and at least one of the memory chips, maybe both, and maybe MCU as well, but it is not clear.
feedback.loop:
A couple of red LEDs on the front panel have lenses broken off. These seem to be Panasonic LN282RPX, which are obsolete.
https://www.digikey.com/product-detail/en/panasonic-electronic-components/LN282RPX/P547-ND/410764
Any ideas where to get them?
Thanks.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod