Electronics > Repair
Korg Electribe ER-1 mkII repair
feedback.loop:
This Korg ER-1 had a burned 5V DC-DC converter, which, most probably, killed some other important parts such as the micro-controller, DSP and memory. The DC-DC converter was repaired, but there were no signs of life, and the DSP seems to run too hot. At the moment this looks beyond economical repair.
Ordinaryman1971:
Did you price the DSP replacement? Any availability?
feedback.loop:
I see some on AliExpress for $25-30.
I am afraid that having no copy of firmware, it does not make much sense to order expensive parts.
LateLesley:
What about if you could get firmware? It's not free though, and might make it too pricey still.
http://electribe.cc/wp/about/
feedback.loop:
--- Quote from: LateLesley on September 09, 2019, 11:47:11 pm ---What about if you could get firmware? It's not free though, and might make it too pricey still.
http://electribe.cc/wp/about/
--- End quote ---
First of all, this is an update to load through MIDI assuming a working machine with some sort of a boot loader in it at least. I need an image of the flash memory, which is not the same.
Navigation
[0] Message Index
[#] Next page
Go to full version