Electronics > Repair
Lambda EMS 33-33-3 power supply
(1/1)
big jooe:
Hi all,
Have obtained Lambda EMS 33-33-3 power supply but it does not have voltahe setting helipot, only current setting helipot. How to adjust voltage on this supply? ...or someone has a schematic of it?
many thanks
Joe
artag:
It seems to be covered by the manual at https://www.artisantg.com/info/TDK_Lambda_EMS_33_33_3_TP_LB_CE_1568_Manual_201981311314.pdf but presumably in a version that has no or few front panel controls. However section 3.3.2 describes how to program it using the rear panel tag strip which might be appropriate.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod