Electronics > Repair

Lambda EMS 33-33-3 power supply

(1/1)

big jooe:
Hi all,
Have obtained Lambda EMS 33-33-3 power supply but it does not have voltahe setting helipot, only current setting helipot. How to adjust voltage on this supply? ...or someone has a schematic of it?
many thanks
Joe

artag:
It seems to be covered by the manual at https://www.artisantg.com/info/TDK_Lambda_EMS_33_33_3_TP_LB_CE_1568_Manual_201981311314.pdf but presumably in a version that has no or few front panel controls. However section 3.3.2 describes how to program it using the rear panel tag strip which might be appropriate.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod