Electronics > Repair
Lambda Genesys GEN 60-25 Power Supply Calibration
(1/1)
Jay_Diddy_B:
Hi,

I have a TDK Genesys GEN60-25 power supply. The current is accurate. The output voltage is about 5% high.
This power supply is closed case calibration.

There seems to be very little service information available for these power supplies.

Does anybody know the commands to do the calibration?

Regards,

Jay_Diddy_B


Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod