« previous next »
Pages: [1]   Go Down

Author Topic: LCD PSU  (Read 1153 times)

0 Members and 1 Guest are viewing this topic.

Offline RyanGTopic starter

  • Regular Contributor
  • *
  • Posts: 213
  • Country: us
LCD PSU
« on: April 21, 2017, 01:46:39 am »
I have a PSU here that isn't putting out power. I checked the easy stuff and I am not getting anything on the secondary side of the T1 transformer, but I am reading no open circuits on the primary or secondary. The primary has a 2k-ish resistance. Primary side has ~350v. I attached the schematic that I found online. It also has an on/off pin on one of the connectors, so should I connect 5v to it?
« Last Edit: April 21, 2017, 01:57:00 am by RyanG »
Logged
 

Offline Jay_Diddy_B

  • Super Contributor
  • ***
  • Posts: 2766
  • Country: ca
Re: LCD PSU
« Reply #1 on: April 21, 2017, 02:28:47 am »
Ryan,

I have looked at the schematic. I think if you connect pin 1 (on/off)  to pin 6 (5V standby) on CNS1 the other rails should turn on.

In fact measure the voltage on pin 6 of CNS1 to pin 7 or 8 GND and see if the standby supply is working.

Regards,

Jay_Diddy_B
« Last Edit: April 21, 2017, 02:32:35 am by Jay_Diddy_B »
Logged
 

Offline RyanGTopic starter

  • Regular Contributor
  • *
  • Posts: 213
  • Country: us
Re: LCD PSU
« Reply #2 on: April 21, 2017, 03:16:00 am »
I did check the standby and it is good at 5v. I will try connecting it to pin 1 when I get home from work. Thanks
Logged
 

Offline RyanGTopic starter

  • Regular Contributor
  • *
  • Posts: 213
  • Country: us
Re: LCD PSU
« Reply #3 on: April 21, 2017, 05:47:12 am »
Connecting pin1 to 5v turned everything on. I had a very terrible 24v output bouncing between 23v and 26v. I changed out the EC2 cap and it was a smooth 24v after that.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee